[Elecraft] K2 Signal Tracing

[Ken Kirkley]

I am in section II alignment of my K2. I am not getting a signal from my 
antenna jack to the output. I am using Tom Hammond's method of signal 
tracing
using the lead of a capacitor attached to a clip that is attached to an 
antenna. I have a signal when injected at the following test points; 
c143, c141, c53, d6,
and c5. Then at c4 I have a signal on the right hand lead (away from the 
board edge), but no signal on the left hand lead (near the board edge). 
I have already
replaced c4 with a new 820 capacitor, but still no signal at that point. 
Could you point me in the direction that I need to go next?

-- 
73 & God Bless,
Ken/NO4D
http://webpages.charter.net/kgk

Ambassadors For Christ Net +/- 7.280
M-F at 2:00 EST  Sat at 2:30 EST