[Elecraft] Adjusting C22 to calibrate the K2's Frequency Display.(updated)

[vze3v8dt at verizon.net]

I haven't been around the Elecraft history long enough to know, but I recall that earlier versions required CAL PLL on all bands while new versions only require it to be run on 40m.  If the AppNote still is useful information but out of date it should as well be updated to reflect the current hardware/firmware procedures, or at least have a note that says for units newer than "xxx" do "abc" instead.

Mark, NK8Q
K2 #4786

>From: Lloyd Lachow <llachow at yahoo.com>
>Date: Thu Apr 21 13:56:53 CDT 2005
>To: List Elecraft <elecraft at mailman.qth.net>
>Subject: [Elecraft] Adjusting C22 to calibrate the K2's Frequency	Display.(updated)

>  In this piece, found under "construction notes" on
>the E site, it is emphatic about running CAL PLL on
>*ALL* bands...but it's only possible to do it on 40M,
>so...this ought to be changed, eh? 
>
>  LL/K2.4442
>
>__________________________________________________
>Do You Yahoo!?
>Tired of spam?  Yahoo! Mail has the best spam protection around 
>http://mail.yahoo.com 
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com