[Elecraft] Potential Elecraft Kit

[Robert McGwier]

May I suggest that people consider the N2PK Vector Network Analyzer.

http://groups.yahoo.com/group/N2PK-VNA/

So far, I think it is a better design and is cheaper.

Bob
N4HY


Larry Phipps wrote:

> TAPR has a nice VNA project going, www.tapr.org... it was featured in 
> a July/August QEX. They are also going to offer it assembled I think 
> thru Ten-Tec. It does a lot more than an antenna analyzer to boot, but 
> requires a computer so is not portable. It does all the complex 
> impedance measurements, but since it has its own DDS signal source, it 
> can also display gain/loss type measurements, differential phase and 
> gain error, etc.
>
> Larry N8LP
>
>
>
> Julian, G4ILO wrote:
>
>> If Elecraft is going to get into making kits for more sophisticated 
>> test equipment, I'd like to see an antenna analyzer. The MFJ ones are 
>> ridiculously overpriced over here, and it's not practical to bypass 
>> rip-off UK dealers and buy direct because MFJ levy a deliberately 
>> inflated international shipping charge. Besides, I'm sure an Elecraft 
>> product would be higher quality.
>>
>> 73,
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>