[Elecraft] Elecraft K2 S/n 01432 Alignment And Test Part II Question...

[Vic Rosenthal]

Andy GM0NWI wrote:

> I've asked advice on this
> previously and understand what I was told... that was just to turn the 
> screws around so that the "heads" lay on the transistors,
> from the componant side and protruded out the solder side of the 
> "Control Board"... if this is the case, will I need to do any
> reverse stuff with the washers for each transistor...??

This is exactly how the manual says to do it: with the screw head on the flat 
part of the component (voltage regulator) and the nut and washer on the other 
(solder) side of the board.  It's assembled in this order: screw, regulator, 
board, washer, nut.

-- 
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco