[Elecraft] K2 Loss of Audio

[Roy Morris]

Denny,
I have removed the KDSP2 and jumpered the two headers.  I am beginning to think in my case however that the problem is in the P5 connection on the RF board.  I lifted the KPA100 up, turned it over and rested it on a stack of books.  After connecting the K2 up in this open condition, there was no audio.  When I jiggled the female connector to J5, the audio was restored.  I am going to operate the K2 for a while in this open condition.  If all goes well, I will restore the KDSP2.  Maybe I should make a longer audio cable to the KPA100 that doesn't bind when going around the KPA100 shield cut-out.  In my case routing the audio cable around the shield may cause this cable to strain somewhat at P5.  Roy Morris  W4WFB
-------------- next part --------------
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.2 - Release Date: 4/5/2005