[Elecraft] k2 build question

[Michael Pfeuffer]

Hi Ron,

The masking material is the pieces of tape, usually green, around each 
hole.  I found a sharp "case cutter" edge was necessary to remove it.  You 
should have nice, shiny bare metal around the holes on the inside of each 
panel.  That will make sure you get good RF shielding.  The rest of the 
overspray on the won't hurt anything.

--Mike WQ5C
K2 #4693

At 06:47 PM 4/3/2005, Ron McMurray wrote:
>pg # 29 removing masking material , are they talking about the grey overspray
>ron, kc0tdj
>#4857
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com