[Elecraft] Encoder Z1

[Leigh L. Klotz, Jr.]

Jean-François,
Thanks!  I got my replacement Z1 (on my nickel as I broke it) .  Now it 
works great! 
Thanks to Scott and Gary at Elecraft, and hopefully this is the last 
word on the subject...watch those little pins!
Leigh.
JEAN-FRANCOIS MENARD wrote:

> I observed that sometime, 1 out of 100, when I turn Z1 to change or 
> tune frequency, it goes up only 0.01 or down 0.01 too and stuck at 
> this frequency. But if I only tork a little, little bit the Z1 
> encoder, everything return to normal every time.
>
> What is it wrong with the Z1 encoder, bad or defective ??? Everything 
> is well soldered, nothing touch nothing, no cold soldered..... and 
> everything is working flawlessly.
>
>
>
> ===============================================
> Jean-François Ménard / VA2VYZ / FN45aj
> va2vyz at arrl.net
> Elecraft K2 #4130
>
> Site Internet: http://homepage.mac.com/jfmenard
> ===============================================
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.): 
> http://mailman.qth.net/mailman/listinfo/elecraft    Help: 
> http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com