[Elecraft] low bat KX1

[MC Carpenter]

sorry about that I worded that question  wrong, here is the question in a
different  way.

when I go to menu,  the menu screen  is not the same as in the back of the
book for example BAT comes up bae when I look for RPT it comes up as rPe
when I look for STP it comes up SeP is this correct for this programmed chip
the reason I ask is because the first chip I had was by mistake sent to me
un programmed and had to be returned to company. so I am not sure if its NOW
correctly giving the right output.

Where are the suggested settings, I understand the battery reading being
kept at 9 volts or even a little lower but what is best for the other
settings ... because I do not get anything from the audio from either band


...
----- Original Message ----- 
From: "John Mahon" <johnfm1 at optonline.net>
To: "MC Carpenter" <southisland2 at earthlink.net>
Cc: <elecraft at mailman.qth.net>
Sent: Wednesday, September 22, 2004 11:50 PM
Subject: Re: [Elecraft] low bat KX1


> MC,
> The low battery voltage value can be set in one of the menus.
> Maybe you have yours set too high?
> I have my rig set for 7.5V and I don't get a low battery warning until
> it drops to that value.
> Good luck.
> John N2YC
> KX1 336
>
> MC Carpenter wrote:
>
> >even with new batteries the low bat come up is this a adjustment problem
or is a component not of the correct value
> >_______________________________________________
> >Elecraft mailing list
> >Post to: Elecraft at mailman.qth.net
> >You must be a subscriber to post to the list.
> >Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
> >Help: http://mailman.qth.net/subscribers.htm
> >Elecraft web page: http://www.elecraft.com
> >
> >
> >
>
>