[Elecraft] K2/100 power-out change

[Rich McCabe]

On my first K2 I soldered in a 10 turn 1k pot so did not go as high as 1200. 
Have not tried it on the second K2, but will probably give it a try this 
weekend.

Funny you would mention the KAT100. Built one last night and building 
another this weekend. The CAL went OK on this one.

For those interested in the AT, it is a blast to build and looks/works 
awesome. Took about 6 1/2 hours including making cables. Piece of cake :)

Rich


----- Original Message ----- 
From: "Michael Harris" <mike.harris at horizon.co.fk>
To: "Rich McCabe" <r.mccabe at 1967z28.com>
Cc: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Wednesday, September 22, 2004 4:10 PM
Subject: Re: [Elecraft] K2/100 power-out change


> Rich,
>
> Further to my earlier posting.  The resistor to change is R98 on the RF
> board.  I have changed mine from 270 ohms to 1200 ohms and that completely
> removed the power hunting.
>
> Without doing this it is almost impossible to properly set up the KAT100
> if you build one.
>
> Regards,
>
> Mike VP8NO
>
>