[Elecraft] Low Power ?

[John R. Lonigro]

Larry:

I haven't measured my K2 output power for a while, but I recall I can 
get 10 Watts out on 10 meters and at least 15 on 80 meters when I'm 
using a 13.8 volt power supply.  A 12 volt gelcell doesn't allow for 
full output, especially at the higher frequencies.  If you are using 
13.8 volts, you might try to go through the alignment procedure one more 
time.  With your readings, it's hard to imagine there is much wrong with 
the rig.  Of course, you also need to be fairly confident your power 
meter is accurate at these levels.

73's

John AA0VE

Larry Dodson wrote:

>I wonder if my K2 (Serial # 2424 with latest mods and software) is set up correctly and would appreciate comments.  Output power with CAL CURR set at 3.0 amps is as below.
>40 Meters = 10.0 watts out
>30 Meters = 12.0 watts out
>20 Meters = 11.0 watts out
>15 Meters =  8.0 watts out
>12 Meters =  9.5 watts out
>10 Meters =    7.0 watts out
>
>  
>