[Elecraft] K2 Front Board Resistance check

[Don Brown]

Hi

If you are getting a OL display on your meter and you are in autoranging or on a range that can measure greater than the resistance called out in the manual then you are OK. 

Don Brown


  ----- Original Message ----- 
  From: Steve Harpole, DDS.<mailto:dds1 at charter.net> 
  To: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net> 
  Sent: Monday, September 06, 2004 12:58 PM
  Subject: [Elecraft] K2 Front Board Resistance check


  Front board is complete and on page 27 of the K2 manual all of the U1 pins check within limits as well as the ground points at J1 pin 8, and J1 pin 20.   Also pins 15 thru 19  of J1 check out good too.  My question is that I am using a Fluke 87IV and when I check the remaining pins with supposedly values >50k or >1M I get a OL , over limit indication on the instrument.  Is this OK ....should I be getting some sort of value in excess of the stated resistances?   

  Thanks Guys,

  Steve
  KQ4UB
  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  You must be a subscriber to post to the list.
  Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>    
  Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/>