[Elecraft] # 4472 new builder problem

[jerry]

Hi to all,

Just finished Part 2 of the basic K2 and having problems with the VCO Alignment.  I set the K2 to 4 mhz and connected a DVM to the left side of R30 and I read 8.0 v and can not change it by adjusting L30.    I checked the  VCO readings and just  4000 and 7300 were on the high side.
How many turns can you turn L30?  I only seem to get about 1 and 1 half down and i get resistance, don't want to break it.

The manual also says that if you do not get any change in the voltage ( like i have)  to "refer to Troubleshooting".  Well there is no mention of this in the troubleshooting section that I can find.
Any help would be appreciated.

Tnx in advance
Jerry , N2UZ