[Elecraft] Switches

[W3FPR - Don Wilhelm]

Glenn,

Put the first notation on the same page that calls for installation of the 
keycaps.  After they are installed, one must be aware of where the soldering 
iron is positioned or the nasty smell of melting plastic will fill the 
air!!!

The same caution could be observed for the RF board after the relays are 
installed.  For myself, it is just common sense to be aware of where ALL 
portions of the soldering iron are positioned when soldering, but even so - 
'bad stuff will happen' occasionally.

73,
Don W3FPR

----- Original Message ----- 

> As I begin starting on K2 # 4277 I recall something about
> switches being accidently melted when soldering something on the front 
> panel board. To avoid this , what
> page in the manual do I need to notate as to pay extra attention to 
> possibly avoiding this problem ?
>