[Elecraft] Q about XV60 pre-installation in K2 #3121

[W3FPR - Don Wilhelm]

Leigh,

I was looking for your references in my K2 rev F manual and found some of 
the phrases you refer to on page 71.  All the steps you refer to are under 
the pre-installation of the K160RX option (for the 160 meter band and RX 
antenna).

If you look near the top of the second column of that same page, you will 
see a bold information note stating "Do not attempt to pre-install parts 
supplied with the K60XV option.  The K2 must be completed and tested first."

73,
Don W3FPR

----- Original Message ----- 

> I'm at the module pre-installation step of my K2 and am confused by the 
> pre-installation instructions for the XV60.
>
> It looks like some of the parts have been re-numbered, and I can't figure 
> out what steps of the XV60 manual to perform.
>
> I have read the D and F K2 manuals and the XV60 manual, and its errata, 
> and searched the mailing list.
>
> Here are the three questions, in increasing order of my confusion:
> ...snip...