[Elecraft] FW: K2

[CT2GCI]

Hi folks

 

I Have a K2 and I finished the part II of RF board.

I think that the receiver is working fine because I connected an antenna and
I heard CW signals.

The problem is that if I touch any button the receiver stops working and the
s meter goes to 9+40 (end).

But if I tap the MENU button and turn the VFO knob to see the other entries,
then the receiver start's again. Then I tap the MENU button the displays
shows the frequency an all seems ok (sound on the headphones), but if I
touch any button or if I turn the VFO knob the receiver stop's.

I made a revision on the PCB, but all seems OK.

 

Suggestions?  Comments?

 

 

Thanks in advance.

 

 

73's from Portugal

 

Normando CT2GCI