[Elecraft] Faulty resistor pack

[Ron W]

Hi Bob, ( and Reflector readers)
            If you have a look at the Control board diagram, you will see 
that RP3 is 5 x 47k individual resistors.  The one I took out is also 
correctly marked "A 473G"
RP3 1/2 is used with U10a in the ALC circuit
RP3 3/4 and 5/6 is in series with the sidetone cct and U10b
RP3 7/8 is with U10d ( V bfo)
RP3 9/10 is with U10c ( V Bias-xfil)
The fact I can measure it end to end or to any leg with varying resistances 
up to 93k would indicate it is indeed 100% faulty.
I recorded it on the reflector as I don't recall it being mentioned before. 
I suspect it is a component that has "fallen through the cracks" at the 
time of manufacture, and probably somewhat unusual.
Cheers.......Ron ZL1TW