[Elecraft] News from Dayton?

[Mike Morrow]

I wrote:

> ... features would I like on a revised K1 ...
>(1)  A frequency display that shows the whole frequency at once, and 
>(2)  A permanently displayed signal strength bar graph, and
>(3)  A display backlight that can be turned ON or OFF as desired, and
>(4)  Much smaller LEDs for the RIT and Attenuator indicators, and
>(5)  RIT pot center detent.

I forgot an important one:

(6)  A polarized two-pin male plug (similar to the speaker connector) in place near the rear of the RF PCB, to which the KBT1 internal battery pack may be connected.  This would allow the KBT1 to be completely removed or replaced as needed in only a couple of minute's time.  Currently, the two leads from the KBT1 are soldered to the RF PCB.

73,
Mike / KK5F