[Elecraft] K-1 Problem Mounting R2 & R3 on Front Panel Board

Tue May 4 21:10:45 2004

     It was a long time ago, but I believe I had a similar problem and
ended up cutting the connectors down to fit.

On Tue, 4 May 2004, Brian Wruble wrote:

> Hi all:
>
> I am completely unable to get the 2 10K potentiometers, R2 and R3 to mount
> properly on the Front Panel Board of my K-1 kit.  The ground pins are just
> too fat to fit through the holes.  It is obvious that I have to get these
> suckers down much further.  Has anyone seen this?  I am afraid to really
> press any harder.  Suggestions?
>
> 73 de Brian W3BW
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
>