FW: [Elecraft] Resistance Checks

Sat May 1 22:22:01 2004

I've answered my own question. I need to learn how to read my DMM. The 
adjacent pads are 1 to 2 etc. The expected resistance must be over 1K and 
should have looked closer I was receiving 8K. Chalk another up to reading 
the manual.

Rick
WA3TUU

>From: "Richard Klingensmith" <[email protected]>
>To: [email protected]
>Subject: [Elecraft] Resistance Checks
>Date: Sat, 01 May 2004 11:55:35 -0400
>
>I'm building the front panel of a K1 and am checking the resistance between 
>adjacent pads on the top side of the board for U1 (PIC16C77MCU). The 
>instructions are a little unclear about which adjacent you mean. In this 
>case does adjacent mean pins 1 and 2 or pins 1 and 40? The reason for my 
>question is reisitance drops low between pins 11 and 12 (VDD and VSS) and 
>again between pins 31 and 32 (VSS and VDD). Is this normal or do I have a 
>problem. When I check pin 1 to 40 all the way through they are all open.
>
>Thanks for your help.
>
>Rick
>WA3TUU
>
>_________________________________________________________________
>Is your PC infected? Get a FREE online computer virus scan from McAfee� 
>Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
>
>_______________________________________________
>Elecraft mailing list: [email protected]
>You must be subscribed to post to the list.
>To subscribe or unsubscribe see: 
>http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com
>Also see: http://www.elecraft.com/elecraft_list_guidelines.htm

_________________________________________________________________
Mother�s Day is May 9. Make it special with great ideas from the Mother�s 
Day Guide! http://special.msn.com/network/04mothersday.armx