[Elecraft] Component Leads
Ron D'Eau Claire
[email protected]
Sat May 1 01:55:00 2004
The only lead cleaning needed is to strip the enamel off of the wire =
leads
for your toroids after winding them and tin the bare copper. =
Carelessness in
removing all of the enamel is one of the major causes of difficulty with
poor contacts. =20
No other clearing of leads is needed.
Ron AC7AC
-----Original Message-----
From: [email protected] =
[mailto:[email protected]]
On Behalf Of Karl - N7NLU
Sent: Friday, April 30, 2004 10:37 PM
To: [email protected]
Subject: [Elecraft] Component Leads
I'm doing the parts inventory for a new K2 and was wondering if it is
necessary to clean component leads prior to installation? If so, what is =
the
best method?
Thanks, Karl
_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm