[Elecraft] Removing Resistor Packs

[Bill Tippett]

	Well I just made my first major mistake!  I installed
RP2 in the RP3 slot (which is unused but in the same area
and also marked as a 10k on the RF board).  I've removed solder
from the bottom holes such that I can see the pins through
the holes, but the pack will not budge as I heat pins from
the outside edge in and gently pull the pack from the top.  I
believe the problem is solder on the top side underneath the
pack body which I cannot remove.  Before I clip the pack off,
remove the pins and order a replacement, has anyone had
success removing resistor packs?  I only have solder wick
and a hand-held solder sucker so please don't get fancy on
me.  ;-))

				73,  Bill  W4ZV