[Elecraft] Control board resistance checks

[Jim Schnaidt]

I have just finished the control board on my week old K2 and noticed a 
discrepancy with 2 of the resistance readings I'm getting during the 
final control board resistance checks.

The manual says that both the Q1 collector and Q2 collector to ground 
resistances should be > 1M. Both of these points check at 473.9K and 
473.5K using my Fluke 179 DVM.

Since these readings are less than 1M in both instances, I'm wondering 
if this is a problem.

Can anyone say?

All the other resistances are nominal.

73,

Jim
KJ0M

._._.