[Elecraft] KPA100 Shield Mod

[Tom Hammond]

At 03:42 PM 3/19/04, Vic Rosenthal wrote:
>Since my scientific examination of the situation indicates that it would 
>take aproximately 139.78 G's to dislodge the DSP daughterboard, I removed 
>the little rubber strip alledgedly needed to keep it from falling out, 
>thus allowing me to pull the KPA100 straight up.

As did I.

In fact, I found that the added 'protection' of the foam strip made it 
quite a bit more difficult for me to get a 'clean fit' of the KPA100 top 
cover against the back edge of the K2 front panel... as a result, I removed 
the foam strip. No problems since that time.

73,

Tom