FW: [Elecraft] Output power problem

[Dan Barker]

You sure it's not PTTL on T3? There's not a whole lot of components between
+12 and the collectors<g>.

As to Q5, you don't mention your supply voltage, but again, there's not a
whole lot of components between +12 and the collector. I'd say 13.4 is fine.

Dan / WG4S / K2 #2456

ps: PTTL = Poorly Tinned Toroid Leads

<snip>
Both Q7 & Q8

B : 0.6 VDC
C : 0.0 VDC !!! (should be around 13.3 VDC
E : 0.0 VDC

There is also the readings I have with driver Q5 when tuning at 2W

Q5

E : 0.6 VDC
B : 1.2 VDC
C : 13.4 VDC (should be 12.4, but... )

Any idea ???

===============================================
Jean-François Ménard / VA2VYZ
k2 at cima.ca

Amateur Radio Club of Sherbrooke, Quebec, Canada

Web site: http://homepage.mac.com/jfmenard
===============================================
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft    Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com