[Elecraft] K2 menu change

[Don Wilhelm]

Paul,

While I can't think of any definite reasons, but it sounds like you are
hearing a carrier somewhere near where the K2 input is tuned (28 mHz band).

One question - have you updated your KPA100 with the recent changes or do
you have a recent KPA100?  If not, an artifact from the crystal frequency in
the KPA100 may be what you are hearing - the update changes that crystal
from 16.289 to 18.432 mHz.

73,
Don W3FPR

Life is what happens when you are making other plans

----- Original Message ----- 
This weekend I tried to connect two XV transverters to my K2/100.  The K2 is
updated and has the 60 meter mods installed.  When I went to the menu and
changed Transverter 1 from off to on and then punched in the 5000 as
directed I have a soft steady tone from the speaker while in the CW mode.
If the mode is changed to Upper SB then the tone intensifies and gets higher
and louder.  When changed to the Lower SB mode the tone is gone.

This all will occur with everything connected to the K2/100 back panel and
again with nothing connected to the K2/100 back panel.