[Elecraft] Re: how to K2 scan

[wayne burdick]

Hi David,

Store A & B VFOs (start/end frequencies) in a memory (0-9) using STO. 
You can start scan by cointinuing to hold STO until you see "SCAN" on 
the LCD, or RCL the memory at anytime and hold until you see "SCAN". 
You'll also probably want to assign either PF1 or PF2 as scan resume.

If you have the latest K2 firmware (2.04), you have an additional 
scanning option: hold STO or RCL longer, until you see "SCAN" and then 
"AF ON". This turns on non-muted or "live" scanning, which doesn't 
stop. Use 10 Hz tuning in this case. It's useful for scanning a band 
looking for very weak signals that would not stop the normal scan 
routine.

Finally, the latest firmware also handles channelized scanning. This is 
especially useful for the 5 channels authorized on 60 meters.

Have fun--

Wayne
N6KR

On Jun 19, 2004, at 7:24 PM, David Walker wrote:

> How do I get the K2 into SCAN mode again!!!....


> ---

http://www.elecraft.com