[Elecraft] K2: Toroid Wire

[Don Brown]

Hi

I have found Elecraft supplies about twice the amount of toroid wire required. You will have plenty of wire.

Don Brown
KD5NDB


  ----- Original Message ----- 
  From: Linden, Mike (BRC-Hes)<mailto:Mike.Linden at boschrexroth-us.com> 
  To: 'elecraft at mailman.qth.net'<mailto:'elecraft at mailman.qth.net'> 
  Sent: Wednesday, June 16, 2004 3:15 PM
  Subject: [Elecraft] K2: Toroid Wire


    Just out of curiosity, if you use as the amount of toroid wire specified
  in the K2 manual, is there enough left over to rewind a few toroids?

    Thanks, Michael  N9BDF
    K2 #4137


  PS  The "Amateur Radio Emergency Communications Consistency Act" (HR 1478)
  and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are in
  Congress. Please contact your Congressmen to ask for their support of these
  bills! See the following ARRL link for details:
  http://www.arrl.org/govrelations/<http://www.arrl.org/govrelations/> <http://www.arrl.org/govrelations/<http://www.arrl.org/govrelations/>> 


  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>
  You must subscribe to post.
  Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft page: http://www.elecraft.com<http://www.elecraft.com/>