[Elecraft] #5-40 TapTite screws for KPA100

[W4FMS at aol.com]

Hi All:

I'm just finishing up my KPA100.  I see that the #5-40 TapTite screws used
for fastening the K2 side panel to the slotted edge of the heat sink are not
included in the kit.

I've yet to even use the standard screws in the slot.  I'm wondering if it's
better if I just order the TapTites now rather then end up stripping the
hole out later?

Does the use of the TapTite screws work as a preventative measure?  It seems
just providing a threaded hole from the get-go would have been a better
solution.

Frank, W4FMS