[Elecraft] Scanning

[Kevin Rock]

I was going to set my K2 up to scan again when I noticed the scan resume 
feature notes on page 97.  It states: "The frequency will jump up 0.5 kHz 
to avoid having scan re-lock on the same frequency."  How do I get mine to 
do this?  I've never had it jump 0.5 kHz.  Is there something I am missing 
in the scan setup procedure?  It scans just fine and then when I hit PF2 
it starts at the very same frequency.  I normally restart the scan by 
turning the tuning knob if the thousands place decimal point is blinking.  
Otherwise I start the scan again and manually tune upward to avoid 
relocking.  How do I get it to work like in the manual?  That would be 
convenient.
    Kevin.  KD5ONS