[Elecraft] K2 Troubleshooting

[Don Wilhelm]

Scott,

The most common failure point is a solder joint.
So first check soldering, then re-check the soldering, and finally check all
soldering.

We will need more details of what works and what doesn't (what do you see on
the display, what do you hear in the headphones, and under what conditions,
etc.) to give further informative advice (at this point we can only guess
based on the limited information available).

73,
Don W3FPR

----- Original Message ----- 
From: "Scott Cashel" <KJ5ME at comcast.net>
To: <elecraft at mailman.qth.net>
Sent: Thursday, July 29, 2004 12:55 PM
Subject: [Elecraft] K2 Troubleshooting


Good Day,

I have completed the assembly of the control board, front panel, and initial
rf board
and assembled same. On power up the background illuminates and some clicking
occurs but
nothing else. I have disassembled and rechecked component locations and
retouched the
solder connections several times. Although I can find nothing wrong I
obviously have made
errors somewhere. I am not an engineer and I appear to be in over my head.

Please Help!

Scott Cashel
KJ5ME
Arlington, TX
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com