[Elecraft] Re: Elecraft Digest, Vol 3, Issue 17

[wa2dkg at juno.com]

Don's advice is correct...However, sometimes the feet are not the
problem...If there happens to be a slight twist in the  "chassis", the
feet will not contact the table equally and a rock will result...If
adjusting the feet does not work, try loosening EVERY screw on the
outside of the case about 1/2 turn, meaning ALL screws, top, bottom,
rear, etc...Do not loosen the two nuts on the heat sink that hold the
final transistors...Set the K2 on the bench with the stand folded and
apply downward pressure to the case with one hand while re-tightening all
the accessible screws with the other...Try to position the radio so that
you can reach all the screws without releasing the pressure...This will
force the case to lie flat while the screws are tightened...Turn the
radio over and tighten the bottom screws...

Jerry, wa2dkg