[Elecraft] K2: Alignment and Test Part II

[Linden, Mike (BRC-Hes)]

Bob,
 
  I agree... In my case, the voltage at 3.5 MHz was the ONLY voltage that
was anywhere near a limit.
 
  Thanks, Michael N9BDF
               K2 SN #4137

  _____  

From: G3VVT at aol.com [mailto:G3VVT at aol.com] 
Sent: Friday, July 09, 2004 8:10 AM
To: Linden, Mike (BRC-Hes); elecraft at mailman.qth.net
Subject: Re: [Elecraft] K2: Alignment and Test Part II


The VCO voltage reading is within the tolerances quoted by Elecraft so is
normal.
 
However this is not the whole story as you have to look at the results for
all bands rather than just this one and ensure that they also fall within
the stated limits. On my K2 on 40m with 80m set as advised in VCO alignment
(P61) in Alignment and Test, Part II, 7000kHz was below the quoted figure of
greater than 1.5V. This meant a juggling act to balance up the readings.