[Elecraft] Transverter Alignment Procedure Part 1

[Don Brown]

Hi

This is normal most of the time the pot will be at max. Don't worry be happy

Don Brown

I have built 5 of them number 6 on its way


  ----- Original Message ----- 
  From: Paul<mailto:pfb at adelphia.net> 
  To: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net> 
  Sent: Thursday, July 01, 2004 7:06 PM
  Subject: [Elecraft] Transverter Alignment Procedure Part 1


  Reflector Members,

  Instructions say :

  Measure the TP2 near L1 in the upper left corner of the RF board.  This is the low-noise amplifier (LNA) bias level.  Adjust R13 for between 200 and 275 mV (250 mV nominal).



  All I can get from R13 fully clockwise is 245 mV.  Will this present a problem being at the "fully clockwise" position and being under the rating that is considered the "nominal" setting?  This is an identical reading for two separate transverters.

  Paul
  K8QT
  K2/100 #3479
  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  You must be a subscriber to post to the list.
  Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>    Help:  http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/>