[Elecraft] Strange KNB2 Behavior

[Douglas Westover]

Hi Tony,

Well that is a relief, I'm glad I'm not the only one to
see this behavior. I too seldom use the low
threshold so in normal operation it probably
would have been years before I found it!
I guess the first thing I'll do is plug in the old
KAF2 and see if the problem goes away.

73,
Doug
W6JD

----- Original Message -----
From: "Tony Fegan VE3QF" <ve3qf@rac.ca>
To: "Douglas Westover" <westalto@worldnet.att.net>
Sent: Friday, January 30, 2004 10:55 AM
Subject: Re: [Elecraft] Strange KNB2 Behavior


> Hi Doug,
>
>     I just wanted to tell you that my K2  threshold switching behaves
> exactly the same as yours. I have never noticed this before. My
> threshold usually sits on high and I rarely change it. I do have the
> KDSP2 installed. I think our  poor old front panel switches  and
> firmware  are really hard pressed to perform without a few conflict
> oddities.
>
>        73
>
>           Tony Fegan VE3QF
> K2 #490 with all the bells and whistles (not upgraded fully to 3000 plus).
>
>