[Elecraft] KX1#383 PASSED! Part-1 Alignment!

Sat Jan 10 22:08:01 2004

Moral of the story builder fatigue! ...taking a walk and dinner was the
ticket! Doubled check resistances they all passed ...moved on to the Part-1
Alignment! it PASSED! YES! 8~) Thanks to the list for listening and helping!

Back to the solder for round 2!

> ----- Original Message -----
> From: "SteveG" <[email protected]>
> To: "Elecraft List" <[email protected]>
> Sent: Saturday, January 10, 2004 6:24 PM
> Subject: [Elecraft] KX1 Part-1 Resistance checks
>
>
> > KX1 .>>>H E L P Please<<< KX1 Part-1
> >
> > I get to measuring the resistance checks on p26 of the manual.
> > Table says:
> > "U1 pins 8 and 19 should be < 5 ohms"
> > I get .9 ohms on pin 8 (this is OK it's less than 5 ohms)
> > Next on pin 19 I get ~ohms (many megohms - like open circuit!)
> > matter of fact alll pins15-28 measure in the high meg ohms this can't
> > correct??
> >
> > Question is: is this oK?? Dare I drop in in U1 and go for the next
> phase??!?
> >
> > Taking a walk, ...Steve/n0tu
> >
> > _______________________________________________
> > Elecraft mailing list: [email protected]
> > You must be subscribed to post to the list.
> > To subscribe or unsubscribe see:
> http://mailman.qth.net/mailman/listinfo/elecraft
> > Elecraft Web Page: http://www.elecraft.com
> > Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
>
>
>