[Elecraft] K2 Frequency calibration

[Thomas Beaudry]

>> While on this topic...  I've got a previously owned K2 that didn't
>> come with the cable(s) to attach to the test points.  I assume that
>> I can get them (or at least the ends to make them) from the Mfg?
>
> You certainly can.
>
> Assuming your K2 is NOT one of the very first 300-400 units sold
> (which used a different type of TP jack, you'll need to order the
> following parts:
>
>          Elecraft
>   Quan   Part No.  Description
>
>     1    E530067   10pf cap Axial Leads
>     1    E620044   1-pin male probe tip
>     1    E620021   2 pin female housing
>     3    E620022   female crimp pins
>     1   E980028   4" heat shrink, 3/16" dia.
>     1    E760010   3' RG-174 Coax Cable
>
> The 3rd female pin is a backup in case you botch one. And there's
> a LOT more RG-174 than needed if they actually send you 3 FEET.

Actually the third pin is for the voltmeter probe.  For that probe, 
he'll also need a second 2 pin female housing and some hookup wire.

-- 
Thomas M. Beaudry
k8la / ys1ztm
K2 # 3422