[Elecraft] 160RX Not Recognized by MCU

[Sverre Holm]

> I've been out of two for a few weeks and upon my return I 
> fired up the K2 (SN=3043). I tried to switch to 160 and the 
> rig does not recognize the 160RX module. I accessed the menus 
> and found that I do see the RXant on/off function. The RX 
> antenna seems to work fine as well.

Hi 

I would measure the coil of the 160m relay with an ohm-meter. The K2
recognizes its presence by sensing it. Check for poor solder joints at
or near the relay or the PCB connector.


--
73, 
Sverre

------------------
Sverre Holm, LA3ZA
www.qsl.net/la3za