[Elecraft] Need help with Bargraph Current Test on K2

[James T. "Jim" Rogers]

Hi all,
    I thought I was home frree with the Part 1 Allignment on my K2.  But
when I got to the Bargraph Current test I found I could not get all the
segments of the LED to light when I changed  the GRPH mode to BAR.  There
was no increase in the current as I would expect since all the segments
didn't light up.  All tests up to that point were fine.  I know all the
segments of the LED are working since I can get each of the 10 segments to
light when i change the RF GAIN.  Any ideas?

Dave N1PT

When you changed the rf gain and got ALL the segments to light up, did the
current change. IF so you just passed the test. If not check around U3A and
Q11 on the control board.

73 Jim W4ATK
K2 #4028