[Elecraft] K2 initial testing, follow up 2

[wil.zeebregts@xs4all.nl]

Hi all,

My problem with the LCD display only stating "ELE" after power up, as I have e-
mailed to the reflector earlier, is now gone! I checked all circuits on the frontpanel 
board, as suggested in an e-mail in the reflector's archives, and found a solder splash 
between pins 1 and 2 of RP3. RP3 is part of the frontpanel circuit for the SSB option. 
The rest of the frontpanel board looked OK: no shorts to ground or bad solderings.

After power on, the set now gives "Elecraft" and then "7.100" which changes as I turn 
the knob, as it supposed to do. Back to the teststand to continue the alignment and 
tests, part 1!!

Thank you all for your patience and help.


73, Wil PE1JRZ

K2 # 3967