[Elecraft] K1 - Problem

[W3FPR - Don Wilhelm]

Ken,

Either C2 or C2A is to be installed on page 38 of the manual (at least that 
is the page in Rev F).  The board location is below L1 and just above RP2. - 
If you installed C2, then C2A will be left over.

On your 30 meter problem - you can try listening for the 18.1 MHz oscillator 
on another receiver.  Do recheck all the soldering on your 4 band board to 
be certain everything is well soldered and that there are no unsoldered 
connections.  Try re-aligning on 30 meters - you should find a good peak.

For the transmit frequency problem, recheck the Transmit Offset Adjustment, 
and then re-do the operating frequency calibration.

73,
Don W3FPR

----- Original Message ----- 

Hi, with my K1-4;  serial #1951 I have the following symptoms/problems.  I 
sure will appreciate any help given.