[Elecraft] K2 Odd Power issues

[Tom Hammond]

Dan:

Depends upon which MODE you're in when you set power.

Po28 only is active in modes other than CW.

73,

Tom   N0SS

At 07:23 AM 12/20/04, Dan Barker wrote:
>I'm aware of that setting, but the symptom is on 24 only, not on 28. Very 
>odd. Also, I didn't remember that it was for 12 also.
>
>So, I set the Po28 to 15. Now both 24 and 28 show 15.2 as max requested. I 
>set it back to 10. Still both 24 and 28 show 15.2 as max requested. I'm 
>guessing the firmware got lost, at some point, and toggling Po28 fixed it. 
>Now the display is believable, and I've got a couple transformers to 
>inspect for the low power out on the higher bands.
>
>Very interesting result.
>
>Dan
>
>
>
>k4zm sez:
><snip>
>In your Secondard Menu of the firmware there is a setting called 
>"Po28"  it comes defaulted to 10 watts and this controls the maximum 
>output on 12 and 10 meters.
></snip>
>
>
>
>
>________________________________________________________________
>Sent via the WebMail system at visioncomm.net
>
>
>
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com