[Elecraft] (no subject)

[W3FPR - Don Wilhelm]

Gary,

Is the RF gain control fully advanced? - it should have been when you set 
the AGC Threshold for 3.80 volts.
Have you set S-Lo and S-Hi values after setting the AGC threshold?
Did you restore the RF gain to the full clockwise position after setting 
S-HI?

Any of the above would cause the rightmost LED to be on.

73,
Don W3FPR

----- Original Message ----- 

> I'm not sure whether this is a problem or not but after performing the 
> S-meter alignment on p. 47 of the K2 assembly manaual, the tenth bargraph 
> LED stays lit. It is lit whenever I turn on the rig. The AGC threshold is 
> 3.80 Vdc at U2 pin5. I have completed Alignment and Test II with no 
> problems or defects.
>