[Elecraft] K2, Mounting RFC11

[W3FPR - Don Wilhelm]

Ben,

Just put the wires in the holes, push it flat against the bottom of the 
board, snug the wires on top and solder.  It WILL stay in place - not real 
tight, but certainly good enough - there are a lot of K2s out there that 
have RFC11 mounted just that way and I have seen no problem reports about it 
yet.

73,
Don W3FPR

----- Original Message ----- 

> Ok, I found a couple of messages in the files about
> RFC11, but nothing decisive.
>
> The manual says to mount it horizontally on the bottom
> of the board, but the holes are almost on opposite
> sides of the toroid.  This would mean routing the
> wires around the side of the toroid to get to the
> mounting holes, and wouldn't make it too awful secure
> I wouldn't think.
>
> How did all of you you mount your RFC11?  Pictures?
>