[Elecraft] K2 build up-When to install options.

[w7kxb at comcast.net]

Hello K2 Reflectees (??)
When building up a new K2; would it  eliminate some redundent motions while working in a particular area of construction. to install a particular option?  If so, is there a flow chart available?

Carry on

Bill_Harris  


> I'm not sure that's right. Every time I've seen much attenuation, I've not
> been on the right freq. If you look at the height of the peak in
> Spectrogram, it doesn't drop much as you cycle through the widths. A
> primative zero-beat was to go to 100Hz bw, and peak the volume.
> 
> Or, a filter center not near the input pitch will attenuate (by design)
> greatly.
> 
> Dan / WG4S / K2 #2456
> 
> <snip>
> W3FPR - Don Wilhelm
> ... allow better rejection than a narrower filiter and avoid the attenuation
> that occurs with very narrow filters.
> </snip>
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.): 
> http://mailman.qth.net/mailman/listinfo/elecraft    
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com