[Elecraft] k2 4533 build

[Stokest977 at aol.com]

hello
wonder if any one can advise
  have just come up to page 61 elecraft manual
   vco alignment
sarted off ok was able to get  6 volt on 80 mtrs at 4000
   then the metre shot up to 8 volt moving the vfo dial  slightly
  restores to the set volts moving  the vfo dial again  slightly
  it shoots up to 8 volts same on all bands when the metre is
  at 8 volts there is no adjustment  posible at l 30
same on all bands
all caps are correct value  been over all relevant soldering  again
not sure if it is posible to test varicap diodes dont want to 
  start removing them  dont have replacements
if the volts  is set to the correct value and left without  moving
any thingit stays at that value
thanks  all tom g0lne