[Elecraft] KSB2 set up filter question

[W3FPR - Don Wilhelm]

Jerry,

If you have previously set up your CW filters and BFOs- do not change them 
(unless you find you want to later on).  Do initially set up the SSB filters 
and BFOs as indicated - that will get you up and running,  Then refine the 
BFOs (and filter widths) to your tastes, remembering that the FL1 BFO is the 
one used for transmitting and that should be set to best match your voice 
during transmit by listening on a separate receiver.

You can find some information on how to set up the filters on my website 
www.qsl.net/w3fpr - look at the article on K2 Dial Calibration and you will 
find the CAL FIL information in Step 3 of that article.

73,
Don W3FPR

----- Original Message ----- 

> Just finished installing the SSB adapter into my K2 (#4472) and on page 20 
> step 3 it says to set up my filter exactly as shown in Table 3.
> My question is . Why do I have to change the ones for CW and CW reverse? 
> I guess I just don't understand how these filters work.   I plan to run 
> mostly Digital modes,  but will use Voice occasionally.
>