[Elecraft] cold/power on/ transmit on/pa hot! software glitch?

[Ron D'Eau Claire]

Check the CAL TPA temperature setting in your MENU, Stephen.

It's been a while and I've forgotten the exact cause, but a number of ops
discovered that the temperature setting was suddenly way off, causing the
fan to run constantly. Somehow the initial setting got over-written. 

Ron AC7AC

-----Original Message-----

After a month of so of minimal use my elecrafter k2 .. with 
the 100 pa has started to act oddly when powered on
The transceiver goes immediately to a mode with the pa
fan on and says it is over hot ...
if I tune then the fan powers down and the transceiver behaves itself.

I suspect this might be a software issue with the 
detection of temp by the pa thermistor ..
has anyone else had similar experience and 
can anyone suggest a fix?

Thanks

Stephen
zl1any