[Elecraft] Alignment and test part II

[Don Brown]

Hi

The most common problem is with the is T5. Make sure it is wound right and the leads are stripped properly.


Don Brown

KD5NDB
  ----- Original Message ----- 
  From: Rich McCabe<mailto:r.mccabe at 1967z28.com> 
  To: Elecraft Reflector<mailto:elecraft at mailman.qth.net> 
  Sent: Sunday, August 22, 2004 7:42 PM
  Subject: [Elecraft] Alignment and test part II


  Well we are moving right along.  Just got to the Second aliignment and test
  section na dthe 4 mhz osc calibration went fine. The PLL reference range
  test looked good and the range was right in the middle of the road. But when
  I plugged the freq probe in TP1 and did a cal factor to check the VCO is
  says 000000.

  I am going though all my assembly now to make sure I did not miss anything.
  Can anyone think of any common mistakes I might be overlooking?

  Thanks and 73,

  Rich


  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  You must be a subscriber to post to the list.
  Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>    
  Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/>