[Elecraft] K2 First Alignment. Good but no XG1 signal

[Brian Wruble]

Rich, check the errata.  That step has been moved from page 47 to page 64 in
the manual.  Regards, Brian W3BW 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Rich McCabe
Sent: Saturday, August 21, 2004 4:42 PM
To: Elecraft Reflector
Subject: [Elecraft] K2 First Alignment. Good but no XG1 signal

I am building my second K2. I bought an XG1 after the first one was complete
so did not use it on the other build until after it was running.

I am to the point in the process where I just did my first alignment step.
Everything was perfect and S meter calibrated fine. There is a note that
says if you have the XG1, you can use it to get your 50mv S9 signal at this
point.

They do not give you much more detail than that. So I attached it to the BNC
at the back and nothing.  Looking over the schematic It looke like W1 might
have to be installed. I did not spend much time looking but that seemed to
be the case.

So, should you be able to use the BNC and XG1 and get a signal?  Seems like
the RF board is not far enough along to do that yet.

73,

Rich
kd0zv


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft    
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com