[Elecraft] RE: KX1 RX Sensitivity on 20M vs 30M, 40M

[Leigh L. Klotz, Jr.]

I think the manual says to squeze one of the output toroids until you 
get less output on 20m than on 40m, as a sign that the filter is 
properly adjusted for harmonic reduction.

When I was building my KX1, I brought it to a PAARA club meeting where 
Wayne was speaking, and he looked at my KX1 toroids which were evenly 
distributed, and said I needed to follow those instructions in the TX 
portion of the manual.

On Sat, 21 Aug 2004 10:11am, Eberhart, Russell wrote:
> Into a 50 ohm dummy load, and into 1.0-1.1 SWR antennas, I get about
> 3.3-3.5 watts out on 40M, 4 watts on 30M, and 3.0 watts on 20M.  Have
> re-aligned...get the same.  Is this typical?

73,
WA5ZNU Leigh